Report as Inappropriate

You are reporting a comment on Filament Width Sensor Prototype Version 3 as a violation of the Thingiverse Terms of Service. Thank you for taking the time to bring this matter to our attention. To help our team best respond to this issue please take a few moments to describe what brought this matter to your attention.

Good afternoon!
I have successfully assembled filament sensor that outputs a voltage proportional to the diameter - 1 mm - 1V.
But there is a problem in Marlin.

The "MEASUREMENT_DELAY_CM" works with a value of up to 5 cm.
Moreover, during operation, the delay time randomly varies from 1 cm to 5 cm.
And I have a "Bowden" - 69 cm !!!

Marlin - 1.1.0-RC3 - 01 December 2015 (the only version, which once earned the sensor).

Please, help!
I apologize for bad English.