Report as Inappropriate

You are reporting a comment on DJ105, 105mm brushless quadcopter as a violation of the Thingiverse Terms of Service. Thank you for taking the time to bring this matter to our attention. To help our team best respond to this issue please take a few moments to describe what brought this matter to your attention.

I have a FlashForge Creator Pro and when I put this in my slicer software it is a TAD to big! Any ideas on what I could do? It is less than a 1/8th Inch of overhang. I was thinking of getting a little bit bigger piece of glass but not sure if my printer would print that much over. :( Just got my Nylon too...