Loading

Watering Can

Made by Engineer9736, uploaded

Watering Can Made by Engineer9736 Feb 15, 2016

Description

Printed the whole thing in one piece, upright, 45 degrees rotated, to get it as large as possible on my 200x200mm UM2 printbed. I recon printing it on it's side in 2 halves would give a lot more overhang than just printing it upright.

0.8mm nozzle, 0.25mm layerheight, 50mm/s. Took 6 hours to print. In the middle of the printing, at the easy parts, i have had the printspeed set to 200% to reduce printtime.

The water leaks veeeeery slowly through the plastic. Like 1 drop after 1 minute. Just got to put a layer of varnish on the inside to fix that. Or water the plants quick enough.

Print Settings

Printer:

Ultimaker 2

Rafts:

No

Supports:

No

More Makes

Liked By

Top