I converted the bed model to some other file formats to make it easy to print a template.

The x-bar-clamp modified to print sideways. This makes the arches stronger. I made the part wider so that the towers on the sides were not too small to print. I used Nophead's truncated teardrop holes hydraraptor.blogspot.com/2008_07_01_archive.html

Erik's pulley was designed for 5 mm pitch belt, but the only belts I could find have 0.2 inch pitch. This is close enough to almost work, but the belt slips sometimes. The diameter and pitch of this part has been modified to work better with 0.2 inch belts.

Note: This was a really easy change if you have OpenSCAD installed. I'm uploading it for anyone who just wants to grab the .stl file.

This is a single board that contains most of the electronics required to run a RepRap. All the components that require soldering are through-hole.

Documentation can be found at objects.reprap.org/wiki/Gen2OnABoard