Spool holder for direct mounting.

I improved the extruder.

I have changed to "Mk7" the drive gear.
Using "624ZZ" the idler bearing, "603ZZ" as a support bearing.

It is a fan nozzle for cooling the filaments that are emitted from the hot end.

※：This is used to print together used to wear a mounter to fix the "x-carriage".

I was able to with two spool to fix the "http://www.thingiverse.com/thing:26523".

Spool width : 76mm/59mm
Spool inner diam : 52mm

I have a dual-extruder to remodel the "http://www.thingiverse.com/thing:38515".

※：There is a need to change the control board RAMPS, etc. will not work in "Generation 6 Electronics" board.

It is a in the shape of a ring to clip.

It is a H-type clip to connect the timing belt T2.5.
Can be used if the to modify timing belt T2.5/T5/T10/MXL parameters.

It is the coupling to convert to the shaft axis of a shaft stepper motors 5mm to 5mm/6mm.

Extruder with a direct drive gear for the Orca v04x.
I have been using ”624ZZ" and "Mk7 Drive Gear".

Was modified to be used in Extruder v10b as the "V9 Extruder Filament Guide 1,75 mm".

Used in conjunction with "(hotend v10) 608ZZ idler Orca 0.4x"

I was set to be used in both vertical and horizontal to fix "iPhone 5 stand".

It is an adapter that converts the size of the "Apple 30 pin Dock" to "Lightning Cable".

To make a stand even when you put in a case iPhone5 fix "iPhone 5 Dock v2".
I've also added support to the case back.

I was with a back support and to develop the "iPhone 5 Dock".
In addition, I have also modified handling of the "Lightning Cable" cable.

I've created using the OpenSCAD reference to "iPhone 5 Dock with Lightning Cable".
Please print it and modify it as necessary because the head of the Lightning Cable has been pretty tight.

Cooling ring for cooling the hot end.
※: possible distance to the bottom end of the hot (thermal core) is attached to the case of 47.5mm

Parametric Herringbone Gear Set for extruder v10/v10b
Gear ratio should be able to print as in the past "DEFAULT_AXIS_STEPS_PER_UNIT" is so close without genuine change. Please modify if not go as well.

Prevent the resonance of the frame.
I have modified to respond to 0.4x.

Adapter to the internal width of 55mm using the spool

Y axis belt clamp table

I was able to install Even with the spool holder beside body.

Tool can be installed
HexKey*3
Tweezers*1
Tweezers*1
Spanner*1-3
Nipper*2
Scraper*1
Screwdriver*1

Tool holders for 0.4x Oeca.
Caution, protrudes approximately 50mm from the body.

DigitalMicrometer*1
HexKey*3
Tweezers*1
Tweezers*1
Spanner*1-3
Nipper*1
Scraper*1
Screwdriver*1

Was replaced with "608ZZ" the standard idler bearings.
With the offset, the feed filament may be smooth.

I tried to make the spool guide base.
Please use the "Printrbot filament guide thingy" together.