This is a laserable Blinky ghost magnet based on Mirks 3d Printable design

Just as title really! A handy wheel used for adjusting the height of the table externally. Mine came with a small aluminium knob that fits on the inside, but its a pain to easily adjust.
This fits on the M10 studding under the machine, and is pretty much the same size as the A4 working area! (You can see where I missed a bit :p)
Really simple mod, and much much easier to adjust the bed height!
Sticks out about 5-6mm out from front of machine.

Mine was purchased from HPC Laser hpclaser.co.uk/index.php?main_page=product_info&products_id=40 so I would imagine it fits most, if not all machines of this type.

A better Y-Axis endstop cable for the Makerbot.

I do need to upload the installed picture. I havent gotten around to taking the pic as I still have to connect it up properly.

This gets away from the thick ethernet-type cables and gives a more secure connection.

EDIT: Installed pics added. Will need a couple of blobs of hot glue will keep it in place.

This is a lens cap for the end of a 2 Inch Astronomical eyepiece. This is suitable for all 1.25 Inch eyepieces. Probably best to make it from HDPE as its more flexible. Though I have still to test it! There are also 1.25 and 0.965 sizes available! Oh, and Ive added in a 1.5mm air release hole.

Not tested yet, so dont know how well the 2mm wall thickness holds up! Will let people know and upload a pic once its done! (I still need to finish making my makerbot, all electronics are nearly complete!)

Edit: Edited to move Origin point to the centre of the part.

This is a lens cap for the end of a 0.965 Inch Astronomical eyepiece. This is suitable for all 0.965 Inch eyepieces. Probably best to make it from HDPE as its more flexible. Though I have still to test it! There are also 1.25 and 2 Inch sizes available! Oh, and Ive added in a 1.5mm air release hole.

Not tested yet, so dont know how well the 2mm wall thickness holds up! Will let people know and upload a pic once its done! (I still need to finish making my makerbot, all electronics are nearly complete!)

This is a lens cap for the end of a 1.25 Inch Astronomical eyepiece. This is suitable for all 1.25 Inch eyepieces. Probably best to make it from HDPE as its more flexible. Though I have still to test it! There are also 2 and 0.965 sizes available! Oh, and Ive added in a 1.5mm air release hole.

Not tested yet, so dont know how well the 2mm wall thickness holds up! Will let people know and upload a pic once its done!

Edit:

Ive removed the air release hole, the printed parts are not airtight anyway, and this makes them quicker and less compex to print. Also reduced the wall thickness and removed the fillet from the big-end.