Thingiverse - letsburn00's Things http://www.thingiverse.com/letsburn00 Fri, 10 Feb 2012 08:31:30 +0100 FeedCreator 1.7.2-ppt (info@mypapit.net) en-us Copyright 2012, Thingiverse.com Mendel y foot with bearing (experimental) http://www.thingiverse.com/thing:3226 thingiverse.com/thing:1708 . His version works without a bearing and uses natural smoothness of PLA to allow easy movement. This is a mod of that design in that it uses a single bearing to slide. This means that if like me you can only print with ABS, then you don't need to worry about the friction effects.

Note that although this is made to be used with a 624 bearing, you can still used vik's design with a bunch of stacked washers. If the hole makes your part a bit too flimsy, then feel free to reduce the size of the bearing groove at the rear of the section.

This will give you less free clearance to use the spring function of the part.

Note: Like the original, this design has requires an active gravity well to operate in, if being used in micro-gravity (or upside down) then use the original Mendel design. ]]> letsburn00 Wed, 26 May 2010 14:30:19 +0100 http://www.thingiverse.com/thing:3226 Printruder I to mendel adaptor http://www.thingiverse.com/thing:3204
This allows you to attached the thingiverse.com/thing:958 printruder I by zaggo and allows you to attached it to the mendel. Note that this basically replaces the insulator retainer.

I really like the printruder Version 1, so I'm using it for my mendel's.
]]> letsburn00 Sun, 23 May 2010 07:07:41 +0100 http://www.thingiverse.com/thing:3204 Basic Clamp for M5 bolt http://www.thingiverse.com/thing:1252
A very basic clamp block, can be used either on it's own, or with two printed off to form each side. I originally made this to tighten down my ABS-wood bed onto my reprap bed, but use it for whatever.
]]> letsburn00 Sun, 08 Nov 2009 16:10:12 +0100 http://www.thingiverse.com/thing:1252 Turntable for a 3d scanner. Both printable or millable http://www.thingiverse.com/thing:784
I actually created this a few months ago and put it on the reprap blog, but never got around to putting it up here. Especially given zignig made and posted his on the exact same day. ]]> letsburn00 Fri, 10 Jul 2009 04:42:33 +0100 http://www.thingiverse.com/thing:784