AT4 Bazooka Conversion (Firework Artillery Shell)
by 2ROBOTGUY, published
Experimental way to convert a used Bazooka Tube into a unique Firework artillery shell launcher.
3D printer can make you some semi useful stuff like whistles or bottle openers, but lets look deeper. Personal 3D printers give you the ability to make custom high precision parts quickly. Allowing you to combine two parts into one Assembly for maximum fun!
Primary Test video (A Must Watch!)
Recent Commentsview all
just to take safety a step further... PVC is NOT the plastic you want to launch fireworks out of, If something goes wrong it can splinter into microscopic pieces that a DR. wont be able to remove from your body HDPE is the tubing of choice for a safer .http://youtu.be/XEqRP_MmWWw
Awesome Thing I LOVE IT! just be safe!
Sweet. Only thing left to do is to adapt the trigger to light the fuze (switch+battery+nichrome?) and you're ready for action.
Liked Byview all
Give a Shout Out
1 X 2" PVC PIPE (12"~20")
1 X 2" PVC CAP
1 X Bazooka Top V1 (Printed)
1 X Bazooka Bottom V1 (Printed
1 X Used Bazooka (~3.3" ID)
1 X JB WELD
1 X PVC Cement
1 X 200 grit sand paper
1 X Knife
1) Print both Top and bottom Bazooka Parts.
2) Check if both parts side snugly on 2" Pipe (Sand parts till they do)
3) Glue 2" cap onto 2" Pipe (Allow to dry)
4)Slide Bazooka Bottom all the way to the bottom of the 2" Pipe (Jb weld in place)
5)Slide Bazooka top 2" From top (Jb weld in place
6)Paint tube if desired. Add Orange ring around the from to identify this is not A real Bazooka
Warning: These machine was build by trained professionals with years of experience. This machine is still experimental and it is strongly advised not to build this. Fireworks are not toys and should be used based on instructions provided with them. I will not be held liable if you build this.
You must be logged in to post a comment.