by MakerMachine, published
We made this mannequin for use in a stop motion video, it has fully articulated limbs and if positioned carefully you can print the joints in one piece.
The video was made as a promo for our campaign to take our makerspace around Australia so if you get a chance please check out our campaign at pozible.com/makermachine.com
Recent Commentsview all
Liked Byview all
Give a Shout Out
Print all the parts, the 2 leg and arm parts will need to be printed twice each. snap the parts together.
we found that the joints after a bit of use would loosen up, putting a small piece of blue tack in the socket of the joint helped itt hold its position.