TRS(Headphone) 3.5mm Male Dummy Plug
23
Likes
386
Downloads
747
Views
Published on July 24, 2011
This thing was Featured on July 24, 2011
Description
A friend of mine wanted something to plug the headphone port on his iphone since it gets used in a very dirty environment and he doesn't use the headhpone port that often. So I modeled up this dummy plug which I modeled off of a 3.5mm TRS(3 pin) Male ipod headphone connector.
I tested this in my iphone, ipod, and computer headphone jacks and it worked in all of them.
Due to their small size it would be a good idea to print multiples of these at one time to give each a chance to cool more before the next layer is added. I was able to print these without using a raft and used the multiple function in skeinforge to print 6-8 out at a time.
I tested this in my iphone, ipod, and computer headphone jacks and it worked in all of them.
Due to their small size it would be a good idea to print multiples of these at one time to give each a chance to cool more before the next layer is added. I was able to print these without using a raft and used the multiple function in skeinforge to print 6-8 out at a time.
Instructions
No instructions provided.
You must be logged in to post a comment.
License
TRS(Headphone) 3.5mm Male Dummy Plug by rullmann is licensed under the Attribution - Share Alike - Creative Commons license.
More from rullmann
Hi. I'm after some of these in black to enable a trip for car radio auxiliary port.... I'm looking at places to get these made as I don't have a 3d printer but I thought I'd ask the creator too. Happy to pay for them.....