Espresso Tamping Stand with Tamper rest
by ewindisch, published
This tamping stand has a place to put your tamper when you're not using it.
The tamper rest is 60mm, so it should nicely fit a 57mm or 58mm tamper without being too tight.
The scad file always references the most recent version of this file.
Tamping_Stand_rest2.stl has been printed and works well without any supports or rafts. Build time was 4h30m on a Replicator 1 clone (Flashforge) printer at .27mm resolution.
Tamping_Stand_rest3.stl has not yet been printed. I found that the small 30mm hole for the portafilter spout is not really sufficient for my Gaggia portafilter. I made the hole bigger and used a cone for the boolean subtraction which should be much more forgiving. I don't expect problems printing this version, but I simply haven't tried it yet.
Liked ByView All
Give a Shout Out
Espresso Tamping Stand with Tamper rest by ewindisch is licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is not allowed.
We're sure ewindisch would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).