Arduino Board Prototyping Mounts
by Hephaestus, published
I know there are several Arduino enclosures on Thingiverse, but I was not happy with their balance between protection and utility (how can you use an Arduino in an enclosure with ports only for USB and power?).
So I am developing my own quick-n-dirty design using a roll-cage type approach that allows for some protection while allowing access to all the IO pins. I haven't printed (and thus checked), or uploaded all
of the pieces yet so this is just a concept placeholder.
I finished (to my satisfaction) the clips for the breadboard and 9V battery (see new photos). I eliminated the end clips because they are now redundant. I should note that this setup is optimized for the Arduino Uno and the breadborad that comes with the ARDX level 1 starter kit. Both items are currently available at Radio Shack.