GoPro HeroHD Case
14
Likes
430
Downloads
1310
Views
Published on July 31, 2011
Description
This is a case for the GoPro Hero HD Camera. I printed this in soft PLA material. It was designed to be mounted on a R/C model airplane. The ribs on the front side are for shock absorbing in case of a crash. There are openings for the knobs and for the direct A/V-Out. Like this it is possible to use it as FPV camera.
--> FPV: First Person View; more info on:
en.wikipedia.org/wiki/First_Person_View
--> FPV: First Person View; more info on:
en.wikipedia.org/wiki/First_Person_View
Instructions
1. Print (preferably in soft material - I use soft PLA)
2. Clean from burrs and drips
3. Open Hole with a knife (for rubber band - see photo)
4. Screw in place
5. Fix camera inside with a rubber band
PS: There are two files - the case and a GoPro model. you might want to use the GoPro model eventually if you have your own plans with the GoPro and if you're fed up in first use calipers to measure yours or to print it out and test fit before you buy it. I think it should be modeled quite accurate.
2. Clean from burrs and drips
3. Open Hole with a knife (for rubber band - see photo)
4. Screw in place
5. Fix camera inside with a rubber band
PS: There are two files - the case and a GoPro model. you might want to use the GoPro model eventually if you have your own plans with the GoPro and if you're fed up in first use calipers to measure yours or to print it out and test fit before you buy it. I think it should be modeled quite accurate.
You must be logged in to post a comment.
License
GoPro HeroHD Case by elk is licensed under the Attribution - Share Alike - Creative Commons license.
More from elk
Thanks! this is cool. I am using a gopro without the waterproof case and i chipped my lens on the first flight. wish i had this before that. but im going to use it from now on.
Hi luke, this is what I want to prevent... but please mind, it has not been tested in flight so far - so I can not guarantee that it will keep your lens safe!