This is a Spool holder for vape coil Spools.
Because some of the spools always want to roll out themselves when you dont want it at all, i`ve made this one.
So whatever material you are going to use for your vape it will always be very easy to get your wire of choice.
It can hold spools with a outer diameter of 6,5cm an a widh of 1,5 cm and a inner diameter of 1,4cm
To secure the Spool you have to mount the Brake arm and secure it with the printable Pin.
it might be necessary to add some Oil or WD40 to provide a better movement of the Brake arm.
To add some pressure just take a rubber band and mount it through the brake arm as shown in the Picture.
Mounting the Spool:
- stick the spool holder through the spool.
- pull the brake arm back and insert the spool with the spool holder in the basement
- release the brake arm back to the spool to hold it in place and avoid unwanted movement.
- pull the wire through the little hole infront of the spool like a Tesafilm holder.
There`s even a Spool holder available for 5 Spool at once.
Just Print 5 Spool Holder , 5 Breake arms and 5 Pins to the big basement
UPDATE: I`ve added the model "Main_Body_V2" which can support larger spools. This one can handle spools up to 8cm diameter
No Support needed
I Printed with a infill of 25%