RepRap Stencil
17
Likes
906
Downloads
437
Views
Published on October 16, 2011
Description
Make your mark!
I included all the files created in the process. I started out using Gimp for the initial design, then saved that to svg and did the rest of the work in inkscape. In retrospect, I think I made this a lot harder than it needed to be, especially considering that the open source hardware logo comes in SCAD format.
I got the RepRap teardrop from here: reprap.org/wiki/RepRapLogo
and the open hardware logo from here: oshwlogo.com/
I'm not sure what the license is on these, so I just used a generic creative commons license.
I included all the files created in the process. I started out using Gimp for the initial design, then saved that to svg and did the rest of the work in inkscape. In retrospect, I think I made this a lot harder than it needed to be, especially considering that the open source hardware logo comes in SCAD format.
I got the RepRap teardrop from here: reprap.org/wiki/RepRapLogo
and the open hardware logo from here: oshwlogo.com/
I'm not sure what the license is on these, so I just used a generic creative commons license.
Instructions
I marked both 3D printer and Laser cutter as required tools because I assume it can be done with either. I don't have access to a laser cutter so I can't say for sure.
You must be logged in to post a comment.
License
RepRap Stencil by polymaker is licensed under the Attribution - Share Alike - Creative Commons license.
More from polymaker
Nothing wrong with taking the long way! especially if the forehead-smack at the end speeds things up next time around.
nice work!