I've seen this 10 times and it always amazes me! Andrew (3dhacker.com)

Hey Jon -

Great Print! I noticed that your prints are glass smooth, can you share the tech specs on how you're achieving this? cheers --Joe

beautiful

This was a four hour print. The results are great. I love the little railings around each of the balconies.

It sure would make a fantastic summer cottage on Nantucket Island where I could run my TOM all by myself. :)

Thanks for the model! Great benchmark in terms of precision.

My print is and 0.17mm layer-height print with 0.085mm perimeter height, scaled at 0.4 and turned 150
˚ for better x/y alignement. Took Netfabb 5 minutes to slice and the Ultimaker did the rest in 10:20 hours.

Sadly I decided to go with a bit of support for the overhangs on the second floor. Didn't do any good, but messed up parts of the façade.

I printed it. Looks great! But I want to print it again before sharing a picture -- such a gorgeous object!

Nobody tried to print it? :(

All I hear is, "Awesome creepy scooby-doo house"