Downloads
Sort By
Deathstar top.stl
169 kb /
127 downloads /
9 months ago
Deathstar middle.stl
47 kb /
125 downloads /
9 months ago
Deathstar bottom.stl
142 kb /
119 downloads /
9 months ago
They Like It
Deathstar by Andr0id is licensed under the Attribution - Non-Commercial - Creative Commons license.
© 2011 by Andr0id
Instructions
1. Print Top
2. Print Middle
3. Print Bottom
4. Glue middle to the center of the bottom's opening.
5. Place light inside if you wish. I suggest adding two small holes to the bottom for access to the LED leads perhaps.
6. Glue on the top.
Suggestions: I use acetone for gluing. Perhaps adding a strong magnet inside would allow you to stick it under metal shelves for display.
