Watering Rose for Plastic Bottle with Threads
73
Likes
620
Downloads
1072
Views
Published on August 8, 2011
This thing was Featured on August 14, 2011
Derived from
Watering spout for 2 liter bottle
by edmo
Description
This is arkatipe's watering spout (rose), with eagleapex's bottle threads thingiverse.com/thing:10489 subtracted from it.
Instructions
Fill a 2L bottle with water and screw this thing on top. Then water your plants!
Works equally well as a field shower.
Works equally well as a field shower.
You must be logged in to post a comment.
ljudmila
on
August 9, 2011
said:
Thanks to you two for making the inputs to this equation!
Made two of these so far and everyone likes them (and wants one to take home). They'll be auctioned off tomorrow for the benefit of a non-profit cultural center in Slovenia. http://www.kud.si/index.php/Pr... Hope this does not violate the non-commercial intent on the l
icence... O:-)
License
Watering Rose for Plastic Bottle with Threads by ljudmila is licensed under the Attribution - Non-Commercial - Share Alike license.
More from ljudmila
This printed well. When sprinkle water there is a little leak between the bottle and spout. I prefer to tell folks that this is because of the cheap bottle thread.
Great picture, Jim!
Does the bottle screw in tightly? Perhaps scaling it down a tiny bit would prevent the leaking.