UsbASP Programmer Case

by gggkkk, published

UsbASP Programmer Case by gggkkk Jun 20, 2013

Thing Info

1169Views 244Downloads Found in Electronics
Report Thing


This is a case for el-cheapo usbasp programmer.

The case is minimalistic and fits in the slots of the cable connector.

Print vertical with 1mm walls and no infill (walls are 1mm).

More from Electronics

view more

Thing Info

1169Views 244Downloads Found in Electronics
Report Thing

Liked By

View All



Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

All Apps

This extension connects Thingiverse with Makeprintable, a cloud-based mesh repair service that analyzes, validates and repairs most common mesh errors that can occur when preparing a 3D design file...

App Info Launch App

Apparently there are 2 versions of the USBasp. Mine is shorter and has LED's along its length instead of across its width. I've drawn up a V2 design for this other USBasp configuration. You can get the file here http://repables.com/r/437/

Sep 28, 2014 - Modified Sep 28, 2014

Fit my betemcu.cn USBasp nicely but the tabs broke off right away. I used a piece of kapton tape to hold it on

Sometimes on little parts like this, I'll print 3 or 4 of them on a plate so that the plastic has time to cool on the little features. It wastes some plastic, but you end up with a nicer part, and you have an extra one to give a friend!

gggkkk - in reply to koss

Yes, the tabs a tiny and could be a problem. Also, they could the printed too wide depending on your settings. I suggest to sand them down to size.

Instead of kapton tape you can also glue to edge of the case to the connector with superglue and make this a definitive case.