Downloads

Sort By
Date
File Type
Please be patient, we are rendering this file.
Gearmotor mount...stl
312 kb / 41 downloads / 9 months ago
Please be patient, we are rendering this file.
Gearmotor spacer.stl
8 kb / 44 downloads / 9 months ago
Please be patient, we are rendering this file.
Gearmotor mount...stl
62 kb / 39 downloads / 9 months ago
Please be patient, we are rendering this file.
Gearmotor clamp.stl
17 kb / 38 downloads / 9 months ago
Please be patient, we are rendering this file.
Gearmotor mount...stl
746 kb / 38 downloads / 9 months ago
Please be patient, we are rendering this file.
Gearmotor mount...stl
631 kb / 37 downloads / 9 months ago
Please be patient, we are rendering this file.
Gearmotor mount...stl
1 mb / 37 downloads / 9 months ago

They Like It

Archimiedies
duckythescientist
MaskedRetriever
jasay
emili
bluelights
jestin
JadeKnight
I-Bioloid
Synchron
Austin
sgraber
Skimbal
blddk
freyzor
pchretien
mirk
mraiser
ncbob
Lanthan
aubenc
Linkreincarnate
Luis
ferret7

Instructions

1) Break away support from front adapter to expose screw/wire holes. (drill if needed)

2) For ABS users glue front adapter on with solvent.
For PLA users drill small pilot holes for two screws and attach with low profile head screws

3) Clamp motors in to main sections. (with screws)

4) Install rear spacers in the original rear axles bearing location.

5) Run wires through hole in the middle.

6) Screw finished assemblies to their respective locations.

Required Tools

Comments