badBrick - Power Brick - (2) 9 Volt Battery Case.
by badBrick, published
Holds 2 (two) 9 Volt Batteries, We wire them in parallel to power an Arduino UNO R3. This case is the power unit to our Buzz and Bark Box.
The case itself can be stand alone or mounted. The (4) rectangular holes fit our mount feet pegs or used as a mount hole.
If you're interested in getting one of these with the wiring harness you can visit us at http://www.badbrick.com/catalog
In MakerWare, I modify the "Medium" settings:
Quality: Layer Height = 0.2 and I increase the temp to 240C to let the little larger prints fuse better.
All other defaults are the same.
** Please note to Maker Ware users. I've downgraded our MW back to 2.1.x and the firmware back to 7.1.
For some reason our STLs were not printing correctly with the new 2.2 update. The slicer was printing partial faces that are not in the model. Just a heads up. You may totally different setup the we have.. So.. Just to know.
Liked ByView All
Give a Shout Out
badBrick - Power Brick - (2) 9 Volt Battery Case. by badBrick is licensed under the Creative Commons - Attribution license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
We're sure badBrick would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).