Loading

Scallopped test piece

by JRD, published

Scallopped test piece by JRD Jun 29, 2013

Thing Info

963Views 158Downloads Found in 3D Printing Tests
Report Thing

Summary

I made this to help someone iron out a specific infill problem on a part that had scallops and motor mount holes at the end of diametric's mini quadcopter arms, without having to print out the entire minicopter frame.

This part is 20mm in X & Y outer dimensions, 4mm thick, with 5mm and 3mm holes, and 7mm radius scallops. This was only an approximation of the actual arm ends.

Diametric's mini quadcopter:
http://www.thingiverse.com/thing:63822

An arm segment from the actual part:
http://www.thingiverse.com/thing:111024

Instructions

Print out at whatever settings suit the need. Start with two perimeters (shells), 10% infill and see if it caps and fills properly.

More from 3D Printing Tests

view more

Thing Info

963Views 158Downloads Found in 3D Printing Tests
Report Thing

Tags

License

Scallopped test piece by JRD is licensed under the Creative Commons - Attribution license.

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

All Apps

This extension connects Thingiverse with Makeprintable, a cloud-based mesh repair service that analyzes, validates and repairs most common mesh errors that can occur when preparing a 3D design file...

App Info Launch App
Top