Loading

Mini Vibration Motor Housing

by lardcanoe, published

Mini Vibration Motor Housing by lardcanoe Jun 30, 2013

Description

Needed a little container to hold a vibration motor so that the weight wouldn't get touched. Also has a hole at the bottom to feed the wires through.

Designed to fit:
amazon.com/Amico-1100RPM-Magnet-Vibration-6x19mm/dp/B0087Y95X4

I wrapped a little tape around the motor to make it snug, which gives the spinning weight a little extra room.

Recent Comments

view all

Probably eventually going to switch over to a coin/pancake vibrator that is completely enclosed. (had a few of these on hand right now though)

A wearable vibro-tactile device... (being vague)

what are you going to do with the motor?

More from Electronics

view more

Liked By

view all

License

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Comments

You must be logged in to post a comment.

braddo_99 on Jul 1, 2013 said:

what are you going to do with the motor?

lardcanoe on Jul 3, 2013 said:

Probably eventually going to switch over to a coin/pancake vibrator that is completely enclosed. (had a few of these on hand right now though)

lardcanoe on Jul 3, 2013 said:

A wearable vibro-tactile device... (being vague)

Top