UNIVERSAL FPV CAMERA MOUNT
by MultiRC, published
Use This Project
Give a Shout Out
If you print this Thing and display it in public proudly give attribution by printing and displaying this tag.Print Thing Tag
This mount was designed to allow you to use basically any FPV camera and set it at any angle with a single M3 screw. It was designed for and works best with smaller form factor cameras such as the HS1177 or small CMOS cameras, allowing the greatest range of angle with these cameras. However bigger case-cams and standard board cams will work as well.
We took what we learned from our HS1177 case and designed something to not only replace it, but allow use of other cameras as well. Where the mounting screw for the HS1177 case was behind the pivot point, this mount puts the M3 mounting hole directly below the pivot to allow it to withstand much greater forces without breaking. It also adds a handy angle gauge with 15° angle markers to help you get repeatable angles.
You will need a 20mm M3 screw and a M3 nut to assemble, as well as an appropriate screw and nut for mounting to your craft.
Upgrade this Thing with Thingiverse AppsCustomization
Edit, personalize, or revise this ThingPrint Fulfilment
Order a print of this ThingTools and Utilities
Repair, slice, or enhance this Thing
UNIVERSAL FPV CAMERA MOUNT by MultiRC is licensed under the Creative Commons - Attribution license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving MultiRC a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure MultiRC would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).