M8 dome nut
by mouserunner, published
Use This Project
Give a Shout Out
If you print this Thing and display it in public proudly give attribution by printing and displaying this tag.Print Thing Tag
wanted some M8 dome nuts to cover the rod ends on my new mendel build.
found http://www.thingiverse.com/thing:27769 and added a dome with some clearance inside.
printed in black PLA at 0.2 layer and 50% fill and came out looking great.
not sure if its my printer but the thread did not come out great but it is very fine, I run an M8 tap in the hole and they work very well.
I nipped them up with a 13mm spanner which is a very good fit and was surprised how much force they will take.
If you bottom them out you will split the dome off the end but I am only using them to tidy up my build and not to hold any load.
M8 dome nut by mouserunner is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving mouserunner a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure mouserunner would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).