Caliper Wall Mount Bracket
by TheKretchfoop, published
This is a wall mount bracket for a Mitutoyo 6" Dial Caliper. I am sure this will work with most 6" calipers available. If not, I have supplied the Solidworks file so you can make a minor tweek if necessary.
Liked Byview all
Give a Shout Out
Printed on Replicator 2X out of ABS on Low settings with 20% infill. Printed vertically with Raft and no support. The .X3G file is included (it is set to print two of these at once). It took about 2 hours 30 minutes.