Jewelry display tree
22
Likes
515
Downloads
941
Views
Published on September 8, 2011
Description
you can cut this from one 12"x24" sheet of wood or acrylic, and the pieces clip together when it's in use, and then fold back flat for storage.
You can hang earrings from the holes, and rings and necklaces from the branches.
You can hang earrings from the holes, and rings and necklaces from the branches.
Instructions
Laser cut according to whatever specs the material needs to cut through.
hold the two smaller tree parts together, and slide the two pegs on each through the four holes on the full tree shape. Slide those tabs downwards, and spread the two small tree parts apart. Then clip the arc piece into the bottom of the two front small tree parts to keep everything in place. When it's assembled, there should be no loose or moving parts. It's very simple and takes just a few seconds.
hold the two smaller tree parts together, and slide the two pegs on each through the four holes on the full tree shape. Slide those tabs downwards, and spread the two small tree parts apart. Then clip the arc piece into the bottom of the two front small tree parts to keep everything in place. When it's assembled, there should be no loose or moving parts. It's very simple and takes just a few seconds.
License
Jewelry display tree by custom3dstuff is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from custom3dstuff
You must be logged in to post a comment.