Loading

Replacement Playstation analog stick.

by matrhint, published

Replacement Playstation analog stick. by matrhint Sep 21, 2011

Description

This is a replacement for an analog stick for a Playstation controller. My dog chewed my original PS3 sticks to the point where it hurts your thumbs....so I made new ones. This can be done to make your controllers look unique if you don't have broken ones.

Recent Comments

view all
Try this one!
thingiverse.com/thing:620207
Just drew it up from measurements taken with a dial caliper. I hope it is a bit more accurate. Let me know if it is not, and I can Adjust it.
Try this one!
thingiverse.com/thing:620207
Just drew it up from measurements taken with a dial caliper. I hope it is a bit more accurate. Let me know if it is not, and I can Adjust it.
Ran into two issues with this model when using a Replicator 2:

- The end thumbsticks are too large to put back through the controller frame
- The posts do not fit into the circuit board

The first issue may be solved by altering the size down a bit (it's about 3 mm too much in diameter) but the post issue would only be made worse.

Liked By

view all

Tags

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Instructions

Print it off using full support, cut off the support, open your controller and replace.

Try this one! thingiverse.com/thing:620207 Just drew it up from measurements taken with a dial caliper. I hope it is a bit more accurate. Let me know if it is not, and I can Adjust it.

Playstation (3) Controller Joystick
by ericsoj

Ran into two issues with this model when using a Replicator 2:

  • The end thumbsticks are too large to put back through the controller frame
  • The posts do not fit into the circuit board

The first issue may be solved by altering the size down a bit (it's about 3 mm too much in diameter) but the post issue would only be made worse.

Try this one! http://www.thingiverse.com/thing:620207 Just drew it up from measurements taken with a dial caliper. I hope it is a bit more accurate. Let me know if it is not, and I can Adjust it.

Playstation (3) Controller Joystick
by ericsoj

<p>Rock and Roll! I can't wait to try this tomorrow.</p>

<p>I am going to try this with pla on my tom soon.</p>

<p>The dimensions are not correct.</p>

<p>I will look on my computer and find the autodesk files and see if I accidentally resized the stl. How far off was it?</p>

<p>I am sorry, I couldn't find the original file. I will make another while I print some parts for another project. Those measurements will speed up the process. Did your dog eat yours too?</p>

<p>Its the thickness of the half circle base that the main problem. I took some measurements of a joystick if you would like me to share, just say so.</p>

I know it is a bit out dated. But, could anyone/you share the dimensions?

<p>Going to try this today..</p>

Top