DIY cutting board for angle grinder
16
Likes
492
Downloads
716
Views
Published on September 14, 2011
Description
This is a bracket for a small angle grinder. It can be mounted around the shaft and has holes for 608zz bearings for connection.
The bracket was mounted between two scantlings which are connected to a board.
I added two fixation brackets at both sides of the blade with holes for M8 bars.
In combination with a ruler starting at the blade it is very easy to cut the bars for a 3D printer.
Read more about this on: ifeelbeta.de
Kind regards
Bonsai Brain
The bracket was mounted between two scantlings which are connected to a board.
I added two fixation brackets at both sides of the blade with holes for M8 bars.
In combination with a ruler starting at the blade it is very easy to cut the bars for a 3D printer.
Read more about this on: ifeelbeta.de
Kind regards
Bonsai Brain
Instructions
Print all parts. Drill holes at the correct positions into the board. Mount the scantlings. Mount the grinder bracket. Drill a horizontal hole through them after marking the correct position of the angle grinder. Mount the bracket between the scantlings. Additionally you may add an endstop.
Cut some bars :-)
Cut some bars :-)
License
DIY cutting board for angle grinder by BonsaiBrain is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from BonsaiBrain
You must be logged in to post a comment.