by CarterStensland, published
3D printed whistle. A total of 2.5 inches in length, .5 inches in height, and 1.25 inches in width. On the inside, it is 2 mm thick featuring a chamber to send the air flow to either the left or the right. The air then continues down the whistle until it reaches the opening of 60 degrees located on the top of the whistle. Any air that doesn't initially go through this opening, will be cycled around and pushed back up into the opening. The decibel reading is approximately 126-128dB.
Printer: FlashForge Creator Pro
Rafts: Doesn't Matter
Supports: Doesn't Matter
The whistle printed very clean and very detailed. The whistle's decibel reading is approximately 126-128dB.
Liked ByView All
Give a Shout Out
Whistle by CarterStensland is licensed under the Creative Commons - Attribution license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving CarterStensland a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure CarterStensland would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).