Flower for a gun barrel
18
Likes
617
Downloads
1307
Views
Published on September 20, 2011
Derived from
Flower - Push Puppet
by Renosis
Description
There's been a lot of argument about weapons on Thingiverse lately. Most of it has been folks talking past each other. Can't we all just get along?
So here's a simple flower that will fit in the barrel of your AK-5000 or whatever. Print one out and give it to your local gun collector, national guardsman, armed gangster, or high seas pirate. After all, everyone needs a flower once in a while.
(The flower is from Renosis' super-fun push-puppet.)
So here's a simple flower that will fit in the barrel of your AK-5000 or whatever. Print one out and give it to your local gun collector, national guardsman, armed gangster, or high seas pirate. After all, everyone needs a flower once in a while.
(The flower is from Renosis' super-fun push-puppet.)
Instructions
You'll probably need to use support material or cut it in half for printing. The openscad file is parameterized for stem length, barrel diameter, and taper.
You must be logged in to post a comment.
Brent
on
September 20, 2011
said:
and how do you know it will "fit in the barrel" what caliber is it? This whole concept is stupid. No offense....
bre
on
September 20, 2011
said:
From the peanut gallery: Might be easier to just put a filament sized hole in the bottom of the flower and use filament for the stem. 8-)
License
More from phooky
adjust it so it fits over an A2 muzzle brake, without sticking anything into the barrel (not really kosher to stick random things in the bore), and it would make a nice muzzle cover for storage.