Castle Grayskull Birdhouse
by DiMarzio, published
Took me quite some figuring out to get it in pieces. Zbrush isn't that when it comes to exact flat surfaces so I hope this will be ok, it looks to me at least. It's meant to stand on a surface, as I made a little ground plate for it. Check the instructions for me info.
I'm not a designer, more of an artist so that will be my excuse :P
As always, pictures are welcome and comments ofcourse too ;-) Enjoy!
Recent Commentsview all
Looks awesome, I'm new to 3d printing so sorry for this basic question. The main Castile front, does that print in the orientation supplied, seems like it would need a lot os support or should it be rotated so it builds upright in the correct orientation. Any printing tips would be helpful, trying this on the XYZ De Vinci
Hello Fabrice, my French is just as good as your English, so no problem ;-) If you want to know if I made the castle with a scanner? I don't have a scanner. I made the castle in Zbrush and after that I made modifications to it to be used as a birdhouse.
Hello, I'm French does not speak well of the castle anglais.Concernant musclor, I would print it on my Ultimaker 2 for ami.Faut use supports it, I would like to settle in cura.Je'll will get some sense soon scanner . I'll make a test scan the castle of my ami.comment you have made ??your file with a scanner?
Liked Byview all
Give a Shout Out
The door can be inserted at the front. You can shove the backplate in and/or glue it. The roof can be put on top of it and so are the towers. Glue at will :)
I made the base with a kind of indentions as where the rocks/front will rest on. I did this because that particular pieces wasn't really flat and I couldn't cut it up more. Also the backplate needed to be put in and rest upon something.
This should be printable with ease. Check scaling if you do so :) All pieces are scaled as to fit with oneanother. Did checking in Netfabb.
You must be logged in to post a comment.