Greg's Hinged Accessible Extruder
35
Likes
930
Downloads
2080
Views
Published on September 25, 2011
Derived from
Greg's Hinged Accessible Extruder
by GregFrost
Description
I added code for mountings for a Parcan hot end with its peek block drilled with 30mm spaced M4 holes.
I have also added a parameter to add a filament guide which I know greg is not keen on adding to his design.
I have also added a parameter to add a filament guide which I know greg is not keen on adding to his design.
Instructions
No instructions provided.
You must be logged in to post a comment.
mattproc
on
January 15, 2012
said:
I found it nigh on impossible to set up the regular version without the filament walking off the hobbing. This seems to have fixed it right up.
4ndy
on
October 31, 2011
said:
Is there a reason why the print in this thing's thumbnail is back-to-front? :S
jridley
on
October 16, 2011
said:
Thanks, I find I really need the filament guide. My copy of Greg's without it keeps failing with the filament wandering to the edge and falling between the bearing and the side wall after about 20 minutes of printing.
More from kyllikki
I dunno if your still around but anyway to make this with the mount for the jhead the scad file doesn't seem to have all your mods :(
ya know the 4 screw mount:)
seems like you moved the hole for the filament slightly over would also be good if we could reduce the motorholder thickness.
not advanced enough in openscad yet to fix these things myself
I wish
but great idea :)
terramir