Description
This is my attempt to create a 608 bearing wrapper that has gear teeth on the inside. Without a belt currently this is not very useful however once I get a few belts I ordered in I will make matching inside gears. I got this idea from makerbot's older method of 1/8 plywood for their 608 bearings.
Flickr Page: flickr.com/photos/31697990@N00/sets/72157622572234151/
Blog Page: blog.synthetos.com/608-bearing-wrapper-and-gear/
Instructions
I used 1/8 plexi-glass and super glue. I also had some 1/4 aluminum spacers that were used to place inside to be 100% accurate on gluing alignment.
So... Cut.. Insert bearing, Glue...
Required Tools
Discussion
Downloads
 |
13.5mm 20 Pressure and Face.svg
73 kb /
136 downloads
|
download
|
 |
13.5mm 20 Pressure and Face.cdr
126 kb /
131 downloads
|
download
|
 |
13.5mm 20 Pressure 10.95mm Center and Matching Face.svg
73 kb /
128 downloads
|
download
|
|
