Small Containers
87
Likes
1236
Downloads
1242
Views
Published on October 4, 2011
Description
Small containers to organize bolts/nuts/washer/everything
The little room in front serve to show an example of what's inside or to put a label.
I wasn't satisfied with the existing solutions here (usually 3-4mm panel assembled) while we can do that in one piece with thin walls (2 perimeters is fine even with hundred of M8 nuts).
Next thing to come is a laser-cut shelves for these containers ^^
Done ! thingiverse.com/thing:12294
The little room in front serve to show an example of what's inside or to put a label.
I wasn't satisfied with the existing solutions here (usually 3-4mm panel assembled) while we can do that in one piece with thin walls (2 perimeters is fine even with hundred of M8 nuts).
Next thing to come is a laser-cut shelves for these containers ^^
Done ! thingiverse.com/thing:12294
Instructions
Maybe better to print in clear PLA to make containers that are almost transparent like on my pictures :)
You can easily add some dividers if you want in sketchup.
It take ~10gr. and ~60min to print with 0.3mm layers at 40mm/s
Also, when extruded above 195°C the clear PLA seem to be less translucent.
You can easily add some dividers if you want in sketchup.
It take ~10gr. and ~60min to print with 0.3mm layers at 40mm/s
Also, when extruded above 195°C the clear PLA seem to be less translucent.
License
Small Containers by watsdesign is licensed under the Attribution - Share Alike - Creative Commons license.
More from watsdesign
More from Containers
Are these stackable?
Hmm no, not yet as I wanted to use them like little drawers
But that wouldn't be hard to adapt :)