Stegosaurus - sliced
22
Likes
412
Downloads
933
Views
Published on October 6, 2011
This thing was Featured on April 8, 2012
Derived from
Stegosaurus
by Hurtzmyhead
Description
I chopped him in half, printed it and stuck him back together!
It's printed with Faberdashery PRINCELY PURPLE and MELLOW YELLOW because everyone needs a Purple and yellow dinosaur in their life!
faberdashery.co.uk/products-page/print-materials/princely-purple/
faberdashery.co.uk/products-page/print-materials/mellow-yellow/
Thanks to Hurtzmyhead for a great low-poly model, it looks really Fab!
It's printed with Faberdashery PRINCELY PURPLE and MELLOW YELLOW because everyone needs a Purple and yellow dinosaur in their life!
faberdashery.co.uk/products-page/print-materials/princely-purple/
faberdashery.co.uk/products-page/print-materials/mellow-yellow/
Thanks to Hurtzmyhead for a great low-poly model, it looks really Fab!
Instructions
This was printed without any support material at 60mm/sec print speed
0.5mm nozzle and 0.3mm layer
Chopped in half and scaled with Netfabb and Sliced with SF41.
He is 1.5 X bigger than the original as a weedy dino is not as much fun.
When printing the Bottom half the back fins will sag as they are not supported, he looks ok, so give it a try.
0.5mm nozzle and 0.3mm layer
Chopped in half and scaled with Netfabb and Sliced with SF41.
He is 1.5 X bigger than the original as a weedy dino is not as much fun.
When printing the Bottom half the back fins will sag as they are not supported, he looks ok, so give it a try.
You must be logged in to post a comment.
NETio
on
April 12, 2012
said:
I must ask, how many bits of filament did you splice to make that nice diagonal pattern?
jwnavagus
on
April 9, 2012
said:
Everybody in Louisiana has an LSU Stegosaurus. It's a Cajun thing. Now stop talking to her in the French Quarter, thats a man, baby. :-P
carlosgs
on
April 6, 2012
said:
Great that you sliced it, the print went quite well (without using support) at 1/2 size. Now i'm making the full print, so far so well :D
Your blog has helped me A LOT, thanks! :)
cyclone
on
October 7, 2011
said:
Nicely sliced. I tip my hat to you. :)
Looks like you managed to mostly get the tail spikes to come out, well played.
License
I am a stegosaurus!