Wire Management for RepRap
17
Likes
448
Downloads
439
Views
Published on October 9, 2011
Description
This "Thingy" makes a 20mm diameter wire clip or a wire conduit. The flexible outside easily opens and clips over the Mendel rod then it snaps tight onto the 8mm or 5/16 rod. The wires are pushed inside and the outside is then compressed so the barb clips/snaps into the grove to lock the conduit.
The clip can be repeatedly snapped and unsnapped to route and reroute wire.
It can also be removed and used again somewhere else.
The clip can be repeatedly snapped and unsnapped to route and reroute wire.
It can also be removed and used again somewhere else.
Instructions
Print 20mm of this or 100mm if you want both stl's are provided.
I skeined it with the jitter module turned on and loop->perimeter->infill print order.
I used PLA with my well calibrated Prusa Mendel with a .35mm hot end and printed on blue tape. First 2 to 3 layers at 200c the rest at 185c.
The dimensions are a hack so it is not intended to be parametric.
I skeined it with the jitter module turned on and loop->perimeter->infill print order.
I used PLA with my well calibrated Prusa Mendel with a .35mm hot end and printed on blue tape. First 2 to 3 layers at 200c the rest at 185c.
The dimensions are a hack so it is not intended to be parametric.
You must be logged in to post a comment.
License
More from PlanoRepRap
Just what I need man!