Tie Fighter Body for Hubsan X4 H107C
by cudbur, published
UPDATE 2-2-2016: Added details, made arms single piece for strength, and fixed proportion of wings. See four parts labeled REV2. Everything printed 0.15mm layer thickness, shell settings.
Alternate body for Hubsan X4 quadcopter H107C. A non-camera module model ( H107L ) is available here: http://www.thingiverse.com/thing:1136405
Have a ready to fly unit made for you or contact us if you need just the 3D printed parts: https://www.etsy.com/shop/cuddleburrito
1 x hull_bottom - shell print settings
1 x hull_top - shell print settings
2 x arm_FLAT_BOTTOM - shell print settings
4 x motor mount - shell print settings
2 x motor arm - shell print settings
2 x wing - 0.15mm layer thickness, solid print settings
Picture instructions here: http://www.cuddleburrito.com/blog/2016/1/1/tie-fighter-conversion-h107c
-Use the screws from a stock Hubsan X4 to fasten the two hull halves together.
-Drill small holes in the motor arms to thread the motor wires through
-The stock motor wires aren't long enough to thread through the arms, so I extended them with wires cut from the x4 part replacement kit
Liked ByView All
Give a Shout Out
Tie Fighter Body for Hubsan X4 H107C by cudbur is licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is not allowed.
We're sure cudbur would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).