Clip-on Z-Stop Companion
44
Likes
488
Downloads
888
Views
Published on October 13, 2011
Description
Does your z-stop seems to have a mind of it's own? i find that every time i switch between abs/pla or adjust my print bed, or switch hotend, i have to re-adjust the z-stop over and over. It has become so tedious that i have to do something about it. And this is what i come up with.
Instructions
Print, clip-on and use.
I only have short M3 springs, so i use 2 with a washer in between.
I only have short M3 springs, so i use 2 with a washer in between.
License
Clip-on Z-Stop Companion by tommyc is licensed under the Attribution - Share Alike - Creative Commons license.
More from tommyc
How did you get the M3 threads to print inside the foot? I'm kidding of course, but the foot does thread on like magic. This is exactly what I needed ans didn't have to disassemble my Prusa to install it. :)