>5cm Spool Holder with 608 Bearing
4
Likes
341
Downloads
291
Views
Published on October 24, 2011
Description
Simple spool holder for filament spools with a hole of approximately 5-6cm.
Instructions
print 2 spool holders
insert a 608 bearing in each spool holder
insert the holders into the filament spool
push a 8mm threaded rod through the holders and fix it with nuts
hang the spool from the ceiling or into a stand
insert a 608 bearing in each spool holder
insert the holders into the filament spool
push a 8mm threaded rod through the holders and fix it with nuts
hang the spool from the ceiling or into a stand
License
>5cm Spool Holder with 608 Bearing by telepath is licensed under the Attribution - Share Alike - Creative Commons license.
More from telepath
You must be logged in to post a comment.