Ash's Chain Saw
33
Likes
456
Downloads
921
Views
Published on October 29, 2011
This thing was Featured on October 30, 2011
Description
Vrroormmmm.... VVVVRRRROOOmmmmm. VVVVRRROOOMMM! VVVVRRROOOMMM VVVRRROOOMMM!
Instructions
1)Print out segments to make a chainsaw of your desired length. (Each segment is 10cm.)
2)Attached segments together.
3)Add Tip to one end.
4)Add end to other end.
5)Bolt finished chainsaw blade to 1 gallon plastic gas can.
6)Cut a hole in the back of the gas can and stick your hand inside.
7)Wave it around shouting at the top of your lungs... Vroommm... VRROOMMM... VVVRRROOOMMMMMMMM!
A special thanks to Annelise Jeske and Tony Sherwood for helping with the pictures!
2)Attached segments together.
3)Add Tip to one end.
4)Add end to other end.
5)Bolt finished chainsaw blade to 1 gallon plastic gas can.
6)Cut a hole in the back of the gas can and stick your hand inside.
7)Wave it around shouting at the top of your lungs... Vroommm... VRROOMMM... VVVRRROOOMMMMMMMM!
A special thanks to Annelise Jeske and Tony Sherwood for helping with the pictures!
You must be logged in to post a comment.
cymon
on
October 30, 2011
said:
A handle on the back of the base, the part inside where you could grip it with your hand, might allow you to swing it around a bit more reliably without holding it with your other hand.
MakerBlock
on
October 30, 2011
said:
Sure, I coulda stayed in the past. Could have even been king. In my own way, I am king.
Hail to the king, baby.
License
Ash's Chain Saw by Skimbal is licensed under the Attribution - Non-Commercial - Creative Commons license.
Listen up, you primitive screwheads!