Downloads

Sort By
Date
File Type
AO-x-end-idler.stl
440 kb / 73 downloads / 4 months ago
AO-x-end-motor.stl
494 kb / 71 downloads / 4 months ago
AO-x-end-clamp.stl
317 kb / 72 downloads / 4 months ago
There was a problem rendering this file.
AO-x-end-idle.scad
3 kb / 60 downloads / 4 months ago
There was a problem rendering this file.
AO-x-end-motor.scad
4 kb / 57 downloads / 4 months ago
There was a problem rendering this file.
AO-x-end-clamp.scad
2 kb / 58 downloads / 4 months ago
There was a problem rendering this file.
nuts and bolts.scad
2 kb / 60 downloads / 4 months ago

Who's Made It?

Aleph Objects Clamp X-ends by Simonious 2 months ago
Aleph Objects Clamp X-ends by fdavies 3 months ago
View all 2 copies

Who's Derived It?

Altered clamp style X ends (SAE and kung fu grip) by jridley 1 month ago
Aleph Objects Clamp X-ends by AlephObjects 2 months ago
ACME lead screw Aleph Objects X-ends by AlephObjects 2014 years ago
x axis clamp with bushing by ekpuz 2014 years ago
RTM X End Clamp, for the Ronthomp Mendel by ronthomp 2014 years ago
Clamp style X-End with 624 bearings by chugadie 2014 years ago
View all 6 variations

They Like It

aosty
lasivian
danielpublic
Simonious
nwk
NewPerfection
ostamo1
Dane
rgoodwin
ronthomp
jebba
Mrrocketman
maxoutny
TREV

Instructions

You will need two clamps and one each of the idler and motor ends.

It is easier to bolt the PLA bushings onto the x-ends first with the 12mm screws and nuts. Then you can bolt the clamp on each end with the 20mm screws, but leave them loose. Once you put the x-end together you can tighten down the clamps.

Comments