Gear Bracelet
Description
Made on TOM MK7 with PLA.
Ready for final filing...but yes, they all turn!
Video of it working without filing...only trimming of all support material.
youtube.com/watch?v=rdVCbWK1KIg
Instructions
You must be logged in to post a comment.
I started making another to see if I could improve the quality by slowing it down by half. The print conked out for filament feed-reasons while not being babysat, but the parts extracted looked much, much better.
Yes, it will take about 11 hours, and make sure you have a nice, continuous feed unless you have a TOM babysitter.
It took just over 4 hours 45 minutes to print. Had some hiccups with the lower teeth on a couple of gears but otherwise mission accomplished! It looks like a piece of architecture all safely bundled up in scaffolding! :)
Please kind sir, what settings do you have in the support section? I have the exact setup, ok not the beautiful clear bot but...TOM MK7 and that same color PLA. I just don't understand support. How long did it take?
I honestly don't know how to tweak the support settings. An engineer at MBI once tweaked them for the MK6+. I'm frankly scared of at least two-thirds of SF.
The print took over five hours at 30% fill, 0.3mm, and 30 speed. I think it would have come out better at a much slower speed, but then it could have taken 10 hours!
I am really glad you saved this from being lost because of one idiots remarks. But it really should be attributed to the person who first uploaded it.
Video of it working without filing...only trimming of all support material.
License
More from nycdesigner
Just finished printing one. Love it! I want to try and separate cogs from frame so this can be printed in two colors using duel-extrusion on a Replicator.