MendelMax Spool Mount
Description
This simple spool mount attaches to the top of your MendelMax. Super simple to use, and quick to change filament. I have only tested this with Ultimachine 5 pound spools, but this should work fine with any spool size. If you find a spool size that does not work with this, please let me know.
Instructions
Print two copies. Attach loosely to the top of your MendelMax. Insert 20mm M8 or 3/4" 5/16" screws with one 608zz through each hole and fasten with a nut. Adjust so the filament spool fits properly, then tighten the screws.
You must be logged in to post a comment.
More from kludgineer
I found I needed to have the bearings on the inside of the spool mount rather than the outside, otherwise a full spool will ride on the frame of the spool mount rather than the bearings.