Faceplate Friction Fit T-Slot 20mm
47
Likes
540
Downloads
907
Views
Published on December 14, 2011
Description
Here is a slotted friction fit faceplate design for 20mm Plastic T-Slot < thingiverse.com/thing:10261 >.
Holes are provided to accommodate M3 bolts either for permanent mounting or to hold in place while framing. As a fully printable hardware system, the holes provide a place to dribble acetone permanently adhering beam to plate. When using bolts take care not to over tighten.
Holes are provided to accommodate M3 bolts either for permanent mounting or to hold in place while framing. As a fully printable hardware system, the holes provide a place to dribble acetone permanently adhering beam to plate. When using bolts take care not to over tighten.
Instructions
Print face up without support. The main failure mode for this piece will be de-lamination of the face to the slot and groove. Printing too fast, too cool, or overcooling can cause this.
License
Faceplate Friction Fit T-Slot 20mm by ProtoParadigm is licensed under the Attribution - Share Alike - Creative Commons license.
More from ProtoParadigm
You must be logged in to post a comment.