Dual Printable T-Slot nut for MendelMax
Description
This is a test sheet of T-nuts.
Some are of the original type posted by kludgineer and some have been elongated for greater support when attaching things to the frame.
The main difference that should help with MendelMAX assembly is a dual t-Nut spaced at 20mm, most things on the frame are spaced for this to assist.
Some are of the original type posted by kludgineer and some have been elongated for greater support when attaching things to the frame.
The main difference that should help with MendelMAX assembly is a dual t-Nut spaced at 20mm, most things on the frame are spaced for this to assist.
Instructions
Print out a sheet and experiment, you should be able to fit a M4 nut into the recess after drilling out the hole and use it as a T-nut.
You must be logged in to post a comment.
Collections
Vitamins and hard ware for 3D printers
by ImaginationFabrication
Misumi things
by TLD-Hardstyle
Openbeam
by wa007
License
Dual Printable T-Slot nut for MendelMax by RichRap is licensed under the Creative Commons - GNU GPL license.
More from RichRap
did you try to use this already?
Yes, I have one machine built with almost all of these