Birdstruder for Mk5/6/6+ Hot End
13
Likes
634
Downloads
1437
Views
Published on November 17, 2011
Derived from
Birdstruder for MakerGear Plastruder
by tommyc
Description
This is TommyC's Birdstruder modified to use replace a Mk5/6/6+ extruder drive. Only the extruder block has been modified for the Makerbot mounting configuration. I've included an STL for the full set and for just the modified drive block. For the other individual part STLs and for assembly instructions, check the original birdstruder page here: thingiverse.com/thing:13628
Instructions
No instructions provided.
You must be logged in to post a comment.
License
Birdstruder for Mk5/6/6+ Hot End by whosawhatsis is licensed under the Attribution - Share Alike - Creative Commons license.
More from whosawhatsis
More from 3D Printer Extruders
w00t... Looking good. Btw just found out that printing an extruder out of PLA when you need to print ABS some times.. isn't that smart an idea... *DONT_KNOW*
I wouldn't even use PLA for a PLA-only extruder. It softens at too low a temperature, and my first Wade's extruder on my Huxley was destroyed by the heat from its motor.