Bunraku knee joint v3
5
Likes
279
Downloads
412
Views
Published on November 21, 2011
Derived from
Small knee joint
by owenscenic
Description
Another revision of my knee joint for a bunraku style puppet. This uses less plastic and has a better range of motion.
It is meant for a 2'-0" to 4'-0" armature. They are also included in my updated thingiverse.com/thing:13477 Legs for a Bunraku Puppet Thing.
It is meant for a 2'-0" to 4'-0" armature. They are also included in my updated thingiverse.com/thing:13477 Legs for a Bunraku Puppet Thing.
Instructions
•Print one of each part.
•Drill out holes if needed.
•Use some 3mm filament or a small bolt (1/8" or 3mm) to be the hinge pin.
•Drill out holes if needed.
•Use some 3mm filament or a small bolt (1/8" or 3mm) to be the hinge pin.
License
Bunraku knee joint v3 by owenscenic is licensed under the Attribution - Non-Commercial - Share Alike license.
More from owenscenic
More from Art
You must be logged in to post a comment.