Yoda bust (cleaned and simplified)
Description
Decimated down to ~200k polys
Cleaned up bad polys at the base
Merged the eyes with the head (separate meshes were confusing some slicers)
Cleaned up bad polys at the base
Merged the eyes with the head (separate meshes were confusing some slicers)
Instructions
Print!
You must be logged in to post a comment.
Busybotz
on
June 10, 2012
said:
Printed Yoda, I did.
.2mm layers looks very good. I am trying another print at .1mm. 8-)
RobH
on
January 7, 2012
said:
When nine hundred years old you reach, look as good you will not. Hmm?
tlalexander
on
November 30, 2011
said:
Is this much different from the existing thing Yoda Lite?
chylld
on
November 30, 2011
said:
Yes; my preferred slicers (KISSlicer and Skeinforge) both fail at slicing Yoda-Lite correctly. Specifically, they exhibit artifacts at the base as well as yucky transitions between eyeball and eyelid.
If Yoda or Yoda-Lite slice nicely for you in your choice of software then there is no need for the derivatives :)
License
Yoda bust (cleaned and simplified) by chylld is licensed under the Attribution - Share Alike - Creative Commons license.
More from chylld
hey,
what is the best kind of infil to print tthis? i mean to use as little of filament as possible? is it possible to print this hollow but with more perimeters?
Jepp, printed fine with 3 shells and no infill and no support. Amazing.