Evil Robot Hand
29
Likes
2612
Downloads
636
Views
Published on December 9, 2009
This thing was Featured on April 20, 2010
Description
So after making the fully printable hinge, I was able to move along with making a hand. Its got all of the degrees of freedom as a human hand. Its a bit bigger then a normal human hand, therefore its evil.
All parts total was about 10 hours of printing.
Available fully assembled here: vendio.com/stores/standardcustom/item/custom-design/-robot-hand/lid=2124336
All parts total was about 10 hours of printing.
Available fully assembled here: vendio.com/stores/standardcustom/item/custom-design/-robot-hand/lid=2124336
Instructions
Print out the parts and clean up the holes. In the fingers use the 3mm plastic filament as the pin so they become hinged.
The slot on the knuckle bar and the slot on the hand bone have an improvised support structure, so you'll have to cut those out when they are finished printing. It should all just slide together afterwards. Enjoy.
The slot on the knuckle bar and the slot on the hand bone have an improvised support structure, so you'll have to cut those out when they are finished printing. It should all just slide together afterwards. Enjoy.
You must be logged in to post a comment.
Anonymous
on
September 22, 2011
said:
Does this need to be rendered on thing o matic in surtain units because it apears bigger than the bed. ???
MaskedRetriever
on
December 10, 2009
said:
My friends and I have a running gag where whenever we watch Battlestar Galactica and the opening sequence shows that one cylon hand with the long needlefingers, we all shout the same thing together.
I think I'll do it now.
SCARY HANDS!!!
License
Evil Robot Hand by jrombousky is licensed under the Attribution - Share Alike - Creative Commons license.
More from jrombousky
I would've used my robot hand for good!